PulseBar NEW DESIGN The NEW PulseBar features a special emitter pin configuration which significantly enhances the bar’s neutralizing and balance performance. The configuration includes an emitter pairing at each end to eliminate potential single polarity hot spots at either end of the bar, and increased emitter quantity in most sizes. Emitter pins are now machined tungsten, not tungsten wire for greater durability and longevity. The PulseBar eliminates troublesome electrostatic charges that can cause dust and other contaminants to accumulate on surfaces and finished product. Featuring a slimline design, the rugged PulseBar can be installed on many types of equipment. It can operate in Steady State operating mode or Pulsed DC operating mode using the PulseFlow Controller. It is easily maintained. It is easily maintained. Available in standard lengths from 12 to 74 inches. REQUIRES A PFC-20 PulseFlow Controller. SPECIFICATIONS: Size (W x H x D) - 0.95" x 1.2" x varied length (2.4 cm x 3.0 cm x length) Cable Length - 7 ft. (2.1m) Material - ABS plastic/anodized aluminum Operating Temperature Range - 24 to 158 F (-10 to 70 C)
